Walking Jack O' Lantern

576

1

Posted in Technology3D-Printing

Introduction: Walking Jack O' Lantern

Ok this is a similar lantern to the others i have produced here except for the arms and legs . so here you go.....

Step 1: Surface Sweeps

Draw a spline long enough for an arm on the plane just about half way into the pumpkin.

Draw an elipse at each end point of the spline, making the one coming out of the pumpkin larger.

Then using surface loft and the spline as a center line create the outer surface of the arm.

You can do the same to create a curled type of hand look, check out the screen shot.

Using, features mirror,  mirror the arm as bodies to copy it over to the other side.

Step 2: Surface Sweeps Again

As like before with the arms use similar techniques to produce the two legs, see the screen shots.....

Share

    Recommendations

    • Spotless Contest

      Spotless Contest
    • Space Challenge

      Space Challenge
    • Microcontroller Contest

      Microcontroller Contest
    user

    We have a be nice policy.
    Please be positive and constructive.

    Tips

    Questions

    Comments