Print PDF
Favorite
Email
Step 6Cut And Crease Page 2 (and part of page 3)
Cut out all of the parts on page 2 as well as part 8 from page 3.
Cut out the paper marked with a red X first, followed by the outside lines, working your way from one side of the paper to the other.
Fold all of the lines as seen in the last picture below.
For parts 21, 22, and 24, there is an X near the center that needs to be cut and folded outwards. The flaps allow these parts to be put over and glued to the main axle (part 20).
Cut out the paper marked with a red X first, followed by the outside lines, working your way from one side of the paper to the other.
Fold all of the lines as seen in the last picture below.
For parts 21, 22, and 24, there is an X near the center that needs to be cut and folded outwards. The flaps allow these parts to be put over and glued to the main axle (part 20).
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
2
May 21, 2009. 8:31 PM"The_Master"
says:
what are the small blue bits for
Reply
11
Jul 9, 2009. 11:33 AMJ_Hodgie (author)
says:
They help guide the cam followers if needed. They attach to the inner two guide squares on the base in ster 12.
Reply
 |
Add Comment
|
