Print PDF
Favorite
Email
Step 7Connect the Servos to the Arduino Board
I'm using the Arduino Servo library, so I use pins 9 and 10 to drive the motors. So my setup looks like this:
Pin 9 -> Orange wire of Servo 1
Pin 10 -> Orange wire of Servo 2
Ground -> Black wires of Servos 1 and 2
VCC -> Red wires of Servos 1 and 2
Pin 9 -> Orange wire of Servo 1
Pin 10 -> Orange wire of Servo 2
Ground -> Black wires of Servos 1 and 2
VCC -> Red wires of Servos 1 and 2
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
