Print PDF
Favorite
Email
Step 2Cut the Pipe
First you will have to cut the pipe into appropriate lengths.
I would suggest 1ft lengths.
On my prototype I used two 1ft lengths and two 1 1/2ft lengths.
I found that this was not necessary, because only 1ft of the 1 1/2ft length was used.
Don't forget to sand down the ends of the pipe so that it will fit into the connector properly.
I would suggest 1ft lengths.
On my prototype I used two 1ft lengths and two 1 1/2ft lengths.
I found that this was not necessary, because only 1ft of the 1 1/2ft length was used.
Don't forget to sand down the ends of the pipe so that it will fit into the connector properly.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
