Wheelbarrow Chair

Step 4 Stand Up

Attaching the legs is pretty self-explanatory: measure up each side from the front lip, scribe through the holes in the legs, drill, and bolt through. Trim any excess bolt length off with a metal grinder or Dremel. Stand 'er up. Put on the most level surface you have around and see how the feet hit the floor. If they're not even, scribe and trim with a hand saw.

I also covered the holes from the original frame with neoprene fender washers, attached with flexible cement and machine screws through to metal fender washers on the inside. This was just to clean up the rough stuff so no one would cut their finger, and also so the colored cushions couldn't be seen from the outside.