Print PDF
Favorite
Email
Step 3Drill small holes to mark where the pins will go
You will end up with 3 pieces... two boards with 2x4's attached and one that is just a board.
On the one that doesn't have 2x4s on it, carefully measure in 1 1/2 inches from each corner and drill a very small hole. Using this board as the "master", line up the board on to of each of the other boards with 2x4s (see picture) and drill into the 2x4's and then turn it over and drill into the MDF as well.
The point of all this it to make all the holes universally spaced on all three pieces.
On the one that doesn't have 2x4s on it, carefully measure in 1 1/2 inches from each corner and drill a very small hole. Using this board as the "master", line up the board on to of each of the other boards with 2x4s (see picture) and drill into the 2x4's and then turn it over and drill into the MDF as well.
The point of all this it to make all the holes universally spaced on all three pieces.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
