Print PDF
Favorite
Email
Step 4Cutting and preping the PCB
for this step i dont have very many pictures but its pretty much straight forrow
1) Remove your new board you just bought at radioshack from its bag
2) I recomend cutting out one of the transfers and using it as a template to get the dimensions right
3) place the transfer on the corner of the board and with a knife score around it
4) Then i placed the board in my vice and used a hack saw to cut it
or if you can get your hands on a band saw that would be much easier
5) once the board is cut out. (image 1) take a peice of 800 grit sand paper and sand down the edges
6) finaly clean of the board with some rubbing alcohal or water making sure to dry it good if used water
next we will transfer the design onto the board
1) Remove your new board you just bought at radioshack from its bag
2) I recomend cutting out one of the transfers and using it as a template to get the dimensions right
3) place the transfer on the corner of the board and with a knife score around it
4) Then i placed the board in my vice and used a hack saw to cut it
or if you can get your hands on a band saw that would be much easier
5) once the board is cut out. (image 1) take a peice of 800 grit sand paper and sand down the edges
6) finaly clean of the board with some rubbing alcohal or water making sure to dry it good if used water
next we will transfer the design onto the board
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
