Print PDF
Favorite
Email
Step 5Step 3: Assembly
1. Gently hammer your 2" Slip x 3/4" FPT (female pipe thread) into one of your 2" by 1 1/2" Reducer Bushings.
2. (Sand the ends of your tube if they aren't smooth to prevent damaging the PVC)
3. You will want the PVC caps (both the assembly from step 1 and the other 2" by 1 1/2" reducer bushing) to fit as snugly as possible in order to prevent propane from escaping. To ensure a tight seal I wrapped each end of the tube in 1/2" masking tape until the PVC caps fit extremely tightly. Next, I removed the PVC caps, put silicone around the circumference, and gently hammered on the PVC caps. Let the silicone dry for the recommended time.
2. (Sand the ends of your tube if they aren't smooth to prevent damaging the PVC)
3. You will want the PVC caps (both the assembly from step 1 and the other 2" by 1 1/2" reducer bushing) to fit as snugly as possible in order to prevent propane from escaping. To ensure a tight seal I wrapped each end of the tube in 1/2" masking tape until the PVC caps fit extremely tightly. Next, I removed the PVC caps, put silicone around the circumference, and gently hammered on the PVC caps. Let the silicone dry for the recommended time.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
