Print PDF
Favorite
Email
Step 6Teeth
I added some strips of foam into the hat opening to make it a little more snug, and covered this with a piece of fabric that was glued in place.
A piece of red fleece was glued down to start the mouth.
For the teeth, I took a strip of white felt that was about 3 by 12 inches and glued it in half lengthwise, with no glue all along about a half inch of the non-folded edge. When it was dry, I cut wedges from the strip to make the teeth
When folded open, the non-glued edge of each wedge created a gluing area for each tooth to be attached to the mouth.
A piece of red fleece was glued down to start the mouth.
For the teeth, I took a strip of white felt that was about 3 by 12 inches and glued it in half lengthwise, with no glue all along about a half inch of the non-folded edge. When it was dry, I cut wedges from the strip to make the teeth
When folded open, the non-glued edge of each wedge created a gluing area for each tooth to be attached to the mouth.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
