Wire Loop Game

Step 8 Applying a Game Board Image

If you want, you can apply a printed image to the top of your game board, gluing it in place as shown in figure. A printable version of the image shown in Figure can be downloaded below. Otherwise, you can use any image you like. When gluing down the image, be sure to leave about 2 inches of foam core exposed for making electrical connections later.

1. Apply a thin layer of glue to the back of your image, as shown in Figure. Be sure to cover the entire surface evenly.

2. Press the image into place, aligning the bottom edge of the image with the bottom edge of your top panel, as shown in Figure. REMEMBER: There should be about 2 inches of uncovered space at the top of the panel.