Print PDF
Favorite
Email
Step 4Sensors and Resistors
Both the Pressure Sensor and the Flex Sensor have tiny leads which can not be sewn into. Soldering a tiny wire to each lead can be tricky but will allow us to form a loop through which we can sew.
We also need to solder a 15K resistor (for each sensor) from the + side of the LilyPad to an analog input pin. For this project we used Analog Input pins 0 and 2, so we need a 15K resistor from +-> a0 and another 15K resistor from + -> a2
We also need to solder a 15K resistor (for each sensor) from the + side of the LilyPad to an analog input pin. For this project we used Analog Input pins 0 and 2, so we need a 15K resistor from +-> a0 and another 15K resistor from + -> a2
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
