Introduction: Wood Engraving | Laser Engraved Skateboard

Picture of Wood Engraving | Laser Engraved Skateboard

To introduce our brand new Speedy 360 flexx machine, we decided to customize a few skateboards to add to our showrooms.

This particular skateboard was engraved using an image of the Joker. However, any type of photo can be manipulated in order to engrave using a laser machine.


Check below to see how we did it!

Step 1: Setting Up the Image File.

Picture of Setting Up the Image File.

For all images, they need to be edited in a graphic design software to allow the machine to do the job. The machine reads only certain colours therefore the photo needs to be manipulated. In this photo, we can see the photo is opened in Corel Draw and Corel Photopaint where we will begin the process.

Step 2: Brightening Up the Dark Areas.

Picture of Brightening Up the Dark Areas.

As you can see with the original image, the darker spots of the photo are very dark. Using the Tone Curve tool, we are able to lighten up the darker areas of the image. The new image is much brighter which will create a better effect for the laser.

Step 3: Unsharp Mask.

Picture of Unsharp Mask.

The next step we need to do is to use unsharp mask. This tool will bring out more detail in the photo and ultimately give the laser more effects to engrave.

Step 4: Convert to Black and White.

Picture of Convert to Black and White.

The last step we need to do to the image to make it laser ready is to convert to black and white. This will darken up some of the lighter gray parts of the image.

Step 5: Time to Engrave.

Picture of Time to Engrave.

Now that the photo is ready, we can prepare the machine and skateboard to be engraved. The first step is to make sure that we measure the exact middle of the skateboard to make sure the image will engrave properly. Since the photo measurements are specific to this skateboard, we are just about ready to engrave.

Step 6: Better Safe Than Sorry.

Picture of Better Safe Than Sorry.

One last step to make sure everything is ready to go; we can outline the job to make sure we will be engraving all the correct spots on the skateboard!

Step 7: Use Your Very Own Image to Personalize Your Skateboard.

Picture of Use Your Very Own Image to Personalize Your Skateboard.

Just remember, anything that can be created in graphic design has the ability to be engraved. For a step by step visual analysis of the steps, please see video attached.

Enjoy!

Comments

TrevorJ44 (author)2017-03-22

Where can I get the final image from.

Linkin_J_Knex (author)2015-10-21

This looks so cool :)

Thanks! Very nice of you to say.

bradleyhillard (author)2015-10-21

That is awesome

Thanks! We're glad you like it.

About This Instructable

1,717views

21favorites

License:

Bio: Trotec Laser Canada provides laser engraving and laser cutting machines for processing a wide variety of materials. Cut, engrave and mark wood, paper, metal, acrylic ... More »
More by Trotec Laser Canada:Point-of-Purchase Acrylic Make-Up Stand | Laser Cut and EngravedMulti-Clock Banner | UV Printed and Laser CutAcrylic Vertical Chess Set | 3D Printed and Laser Cut
Add instructable to: