Introduction: Wooden Spear Shooter
Hello everyone, today I'll be showing you a different way of making a hand-held spear-shooter (original design in link below)
So to make this you will need a small length of a branch, about 5-6 cm wide and 10-12 cm long, a knife, a band-set, a length of inner-tubing, a 20 mm drill bit and some sandpaper.
Step 1: Drilling
Now drill a hole in the middle of the wood. Try to drill the whole as close to the center as possible.
Step 2: Sanding
Now use the knife and sandpaper to smooth it down; bare in mind, the more you sand it, the less grip you will have.
Step 3: Finishing It Off
So the final step is to attach a standard slingshot band set
So that's it, i hope everyone enjoyed this quick tutorial, if you did please comment, vote and subscribe :-)