Print PDF
Favorite
Email
Step 3Parts Needed
1/2 inch 5 ply Plywood 4' x4'
2x4 board 8'
3-1/2" by about 18" 3/4" plywood scrap
Wood glue and some 2-1/2" screws to "laminate" the 2x4 short piece onto long piece and for laminating the lower plywood reinforcement piece for required beam depth to hold Headset (HS).
Kick scooter's: front fork, wheel, Headset (HS), stem and bars
Kid Bike's: single speed coaster brake back wheel (I used 16" size) one piece crank assembly, pedals and Bottom Bracket (BB) assembly of cups, bearings and cones
Extra bike chain (see town's recycling center or bike shop dumpster)
2x4 board 8'
3-1/2" by about 18" 3/4" plywood scrap
Wood glue and some 2-1/2" screws to "laminate" the 2x4 short piece onto long piece and for laminating the lower plywood reinforcement piece for required beam depth to hold Headset (HS).
Kick scooter's: front fork, wheel, Headset (HS), stem and bars
Kid Bike's: single speed coaster brake back wheel (I used 16" size) one piece crank assembly, pedals and Bottom Bracket (BB) assembly of cups, bearings and cones
Extra bike chain (see town's recycling center or bike shop dumpster)
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
