Print PDF
Favorite
Email
Step 7Assemble Headset (HS) on steerer through beam
Install lower race (onto cone so balls (and not retaining clip) touch cone) and cup (into beam) and pass the steerer through beam. Install upper cup into support hole in top of beam. Install bearing race so balls (not retaining clip) touch cup. Screw down the upper race cup onto threaded steerer.
At this point you remember you should have greased the bearings. Take it apart and grease things. Put it all back together. It is either a strange ritual or I'm forgetful, but I can't remember which.
At this point you remember you should have greased the bearings. Take it apart and grease things. Put it all back together. It is either a strange ritual or I'm forgetful, but I can't remember which.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
