WARNING: your controller can break if you do this wrong ( WORKS ONLY WITH WIRELESS )
This is for informational purposes only. use this to have fun. Do not use this in an xbox live ranked game because you are liable to get reported and banned for it
********* Make sure you ar comfortable with using a Soldering Iron because if any solder gets on the circuit board it could creat a short circuit which would break your controller******************
** This controller is not a working mod. This is a old broken controller that I used to show what The wires and stuff should look like. For your controller mod you need to have the one with the silver resistor thing on the front right below where themain xbox controller button is.
Step 1: Supplies
These are the supplies that you will need to complete your project:
1. A soldering iron
2. 22 gauge hook-up wire (at least 2 ft)
3. Solder (I had a small roll of it)
4. 1 momentary pushbutton switch
5. Hot glue gun
6. Xbox 360 wireless controller
7. Torx 8 security screwdriver
8. A drill with a drill bit that fits the size of the button.
MAKE SURE THE SCREWDRIVER IS THE CORRECT TYPE!! I ordered online because it is very difficult to find in stores. also make sure it is the kind with a small hole on the tip.
Numbers 1-5 can all be found at Radio Shack
The cost of this project is about $25 not including the controller