The gun which has had the same general concept to for two years.
A simple tube and stick rifle with a block trig system.
Powerful (can pierce 6-8 sheets of corrugated cardboard)
Fairly easy to make, simple in design
Compact and lightweight
Trigger is far away from the handle
Uses a few cut pieces (but good if you have already cut pieces and want to use them)
Uses so many !@#$%^& snowflake and half-snowflake pieces...
So yeah... I've tried to make this as detailed as possible, the yellow boxes with notes help, I hope. Have fun with it (if you have enough snowflakes mwhahaha)
For increased stability, replace all long gray rods with the harder black ones.
Step 1: Barrel and chamber construction
Step 2: The Lower Part
Step 3: The handle that's made of random pieces!
Step 4: Piecing this sucka together.
Step 6: Foregrip
Step 7: Ram and Bands
Step 8: The Only Somewhat Necessary Mods
Step 9: Firing... YOU'RE DONE!
Pull back the ram until the trigger clicks down all the way.
Push down on the right side of the trigger (I know it's far away...)
CRACK! Rod goes flying.
YOU'RE DONE! Now try to take it apart. You're going to need to sometime if you want to make another gun that uses snowflake pieces. Haha
I hope this was detailed enough... If you need assistance, just put it in a comment and I'll respond ASAP. As slowly as possible.