Introduction: Yarn Fishtail Bracelet
I am so sorry for the lack of Instructables lately! Anyways, this is a really cute bracelet that I made just a few minutes ago and it actually turned out good!
Step 1: Materials
You will need...
•Loom Pick or crochet hook
•Scissors (not shown)
Step 2: Those Two Pegs
You will need two pegs for this project.
Step 3: Feeling Knotty?
Tie a knot as shown in the pictures.
Step 4: To Infinity and Beyond!
Now twist the yarn into a figure eight or an infinity sign.
Step 5: Loopdey-Loop
Now loop the yarn around the pegs as shown once.
Step 6: Loop the Loop Again
Now repeat the last step and move the yarn out of the way.
Step 7: Begin Looming
Grab only the bottom loop and loop it over. Repeat on the other side of your look.
Step 8: Then There Were Two
Now you should have two loops instead of three.
Step 9: Skip to My Loop... Again!
Loop the yarn around another time. You will repeat this step again and again, if you were wondering=P
Step 10: And Loop Both Sides Over
Step 11: Repeat and Repeat
Repeat this process over and over again until you have gotten your bracelet long enough.
Step 12: Now Lets Take It Off
Follow the pictures! I hate having to say that, but it is way easier to follow the pictures=P
Step 13: You Should Have This
Step 14: Take It Off
Step 15: Snip Snip
Step 16: Loop Through
Step 17: Measure Using Approximate Guesses
Step 18: Tie and Cut
Step 19: And Tie and Cut Again
Step 20: Now Wear and Adjust
Step 21: And Voilà!
Great job! Hopefully you have a completed bracelet! Sorry for my lack of elaboration, but you get it, right? Thank you for viewing and I hope you leave comments and requests! Thank you=P
We have a be nice policy.
Please be positive and constructive.