Print PDF
Favorite
Email
Step 10Adding Rubber Bands
1: Loop a rubber band around the front of the trigger as shown.
2: Remove the two white rods, and loop a rubber band over the front like this.
3: Stretch it along the length of the gun, across the blue donuts.
4: Attach it to the firing pin as shown.
5: Add more rubber bands. Alternate above/below the orange connector.
6: Replace the white rods.
7: Remember those two red connectors you were saving? Here is where they go.
2: Remove the two white rods, and loop a rubber band over the front like this.
3: Stretch it along the length of the gun, across the blue donuts.
4: Attach it to the firing pin as shown.
5: Add more rubber bands. Alternate above/below the orange connector.
6: Replace the white rods.
7: Remember those two red connectors you were saving? Here is where they go.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
