Print PDF
Favorite
Email
Step 3Tracing and Cut
I laid the template down and put the plastic mesh on top. Then just traced them out. Repeating the sides 8 times.
For the mushroom I ended up just using the top of it. The stem I just did a circle out of a single piece of plastic, then the bottom was traced after everything else was put together.
Cut out all the pieces along your tracing lines
For the mushroom I ended up just using the top of it. The stem I just did a circle out of a single piece of plastic, then the bottom was traced after everything else was put together.
Cut out all the pieces along your tracing lines
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
