Your first electronic pcb/project

Hehe... Your project is here.
A LED activator.
Simple...

Step 1 Needs...

PCB(above)
LED(small)
510ohm resistor
3v flat button cell battery
Thin wire

Comments

[preetam.daya]

can u plz tel me why particularly u selected a 510ohm resistor only...and also tel me why particularly u selected 3v flat button battery only and also help me with how to select resistors and batteries for any different simple projects

[jwoo2023]

I used a 510 ohm resistor only because it will make the led light up at the brightest, also I didn't use a 3v button battery, i used a 9v. I used the 3v button battery because it's compact, and you dont need a resistor when you use a 3v button cell battery.

[mistic]

i made one of these as a fish lure once. believe it or not it works under water.
i didn't have to glue the electrode wire or solder them onto the cell.i used a little pressure from the plastic case i used. have fun....

[jwoo2023]

wow! did you catch any fish?

[mistic]

The flasher LED attracted fish. Catching the fish required knowledge of bait and lures. I am working on another attractor- a buzzer. It is a miniature relay connected as a buzzer. Hope it works.

[jwoo2023]

Well, Good luck on that!

[noltus]

Blurry pic's

[jwoo2023]

on the last step i said why i have blurry pics

[jwoo2023]

I took the photos again

[hightekrednek2396]

Take better pictures and add pictures of how to connect them also a schematic would help for begginners

[jwoo2023]

on the last step i said why i have blurry pics
and i will add schematics