Z35 K'nex Assault Rifle

Step 10: Handle, Trigger, and Trigger Guard

Without Trigger Guard

1: Build this.
2: Build two of these.
3,4: Attach 1 and 2 with three gray/white rods as shown.
5: Build this.
6: Build this. (the black parts are y-connectors)
7,8: Attach 5 and 6
9: Set the trigger on the handle (they don't attach).
10: Add two blue rods as shown.
11: Build two of these.
12: Add office tape to the tips of the gray/white rods and attach 11.
Go to next step.

OR

WIth Trigger Guard
1-12
13: Build this
14: Build two of these.
15: Build two of these.
16: Attach 13-15.
17: Add a green connector as shown.
18: Pull the blue connectors off of the rifle shell and attach them as shown.
19,20: Add a gray two-slot connector as shown.
21: Attach the trigger guard to handle and trigger.
Go to next step.

Comments

[Dr.Squirrel]

Comfyyy.....But my index can't reach the triger Gotta use middle=( 

[Oblivitus]

That stinks, but I'm 18 and have long fingers, so it works nicely for me.

[Fred the evil puppet]

18? Man, we really need to get a life. But do we want to?
NO! Says the angry mob!

[Dr.Squirrel]

I,m 12=(

[9394]

What are the blue and green pieces on step 5

[I_am_English]

is it me or is the handle really unsteady and flimsy ?

[dansdoc]

is there any way to make it into a pistol??????

ps i dont have enough peices

[ant ant 33]

Oh, I did that in the end anyway, thanks 

[ant ant 33]

 I'M 12 too. Are the bits in picture 11 necessary cuz its comfier without them

[Oblivitus]

They are neccesary only if you are building the trigger guard as well.