Print PDF
Favorite
Email
Step 3Ruler
heat up an area of the ruler and bend it at a 90 degree angle by puttin part of it on a table and bending the other part down.
where you bend it is realy up to you, as long as one end can be taped to the fan, and the other taped to the mechanical pencil.
after it is bent, tape it to the fan so that the part sticking ut is level with the top of the fan. (in the picture, my ruler is a bit too low, and not very firmly taped)
where you bend it is realy up to you, as long as one end can be taped to the fan, and the other taped to the mechanical pencil.
after it is bent, tape it to the fan so that the part sticking ut is level with the top of the fan. (in the picture, my ruler is a bit too low, and not very firmly taped)
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
