Instructables
Picture of cheap button cell holder
The problem that we face is the lack of cheap ,small battery holders

 
Remove these adsRemove these ads by Signing Up

Step 1: TOOLS AND REQUIREMENTS

Picture of TOOLS AND REQUIREMENTS
1.faber castle connecter sktechpens
2.button cells
3.some magnets
4.wire

Step 2: Inserting the batteries

Picture of inserting the batteries
DSCN2470.JPG
DSCN2472.JPG
DSCN2473.JPG
DSCN2485.JPG
DSCN2479.JPG
take the cap of one of your connecter sketch pen and start putting button batteries into it and after putting all the batteries add 2 magnets on each sides

Step 3: Adding wires

Picture of adding wires
before each magnet add one wire each and you are done 

thanks for viewing
Brilliant. I could feel the creativity as I was reading this. Much respect.