In this instructable I will be showing you how to build a simple light up Christmas picture.

Step 1: Suplies

you will need the following

duck tape (any color)
led lights
box (slim is better, pizza boxes work well)
scissors
and something to poke holes (as big or smaller then the lights)

Step 2: Picture

you will need to print out a picture for a template make sure you don't get a really complicated picture

Step 3: Out Line

in this step you are going to put the picture you have selected and start punching the holes on the edge of the picture (make the holes half a inch apart)
once you are done it should look like picture 2

Step 4: Cutting

the only thing in this step is going to cut the back of the box but make sure it is still connected to the box.

Step 5: Adding Holes

you will be adding holes on the inside of the outline to better fit the picture.

Step 6: Lights!!!

you will now be adding the lights (warning) some of the light might pop back out just put them back in until closing box. once finished you can now close the box up but make sure to keep it so you can still get to the lights. make sure to check out the lights to see if it looks good.