ever wanted to have a soda can dispenser but don't want to spend a lot of money? here is your answer. use a old tower from a computer to do the job!

Step 1: You Will Need

you will need: one computer shell with hole for DVD drive either top or bottom that can easily fit a 375ml can for best proformance,one big piece of thick cardboard,one ramp(optional), a pair of scissors, string(optional). if you want your drinks cold you will also need: a powerful fan(approx 9 volts), battery pack, ice pack, plastic sandwitch bag, 2 way switch, insulation(wool works well).

Step 2: Preperation

FIRSTLY, I WOULD LIKE TO SAY THANKS TO MY COUSIN LEE FOR HELPING ME GET IDEAS FOR THIS. Turn tower upside down if DVD drive space is up top.

Step 3: The Ramp

insert the ramp at the back(if you have one)

Step 4: The Cardboard Soda Ramp

with the scissors, create two holes in the cardboard, for string to go through, if you have any.

Step 5: Placing the Ramp

place the ramp inside the shell

Step 6: The String

thread the string through the holes in the cardboard and through the tower, if you have any.

Step 7: Finishing

the shell of your old computer is now a drink dispenser. pull the drink through the DVD drive hole to obtain drink. enjoy! If you want a cooling interface, go to next step

Step 8: The Cooling Interface

note:i am coming up with a efficient cooling interface so hold tight. wire the battery pack to the fan through the switch. this creates a switch to turn the fan on/off. place the switch in an easy to reach place(preferably the floppy drive if you have one). freeze the ice pack and place in the sandwitch bag(helps to stop rusting of the dispenser). this blows cold air at the drinks. with insulation