deburring

deburring drilled or cut edges

Step 1 Rotate deburrer

rotate the deburring tool inside the hole. it is conveniently on a rotating bearing so it follows the edge nicely.

Comments

[sharlston]

can i just say there is another type of deburer that slots into the holder you youse its like a taped cylinder with a sharp blade

[Nicole Lopez]

thank you for showing us the step by step procedure of deburring. I'll try this later.

[kkinney]

I'm not a machinist, but I use an oversized drill whenever I have to debur holes. For the edges of sheet metal, I give it a quick swipe with a vixen file, then a flat file, followed by Scotch-Brite wraped around the flat file.