Introduction: Balloon Gun

Picture of  Balloon Gun

compiled by: Moksham
Here is a list of material's u will need to make "The Ballon Gun" :::enjoy.

1plastic bottle
1 ballon(any size)
small thermocol sheet(optional)
empty pen refills or some bb plastic bullets
a little paint ( any colour)
2 rubber bands.

Step 1: Cutting the Main Body

Picture of Cutting the Main Body

cut the top of the bottle leaving 5 inches.

Step 2: Attaching the Ballon

Picture of Attaching the Ballon

now open the capof the bottle top and put the balloon's mouth above it as shown in the fig 1 .

Now adjust the balloonto the center as shoen in the fig's 2,3.

After that place or put the rubber bands tightly on the balloon's mouth as shown in fig 4.

and last of all to make sure that the baloon does not move from its place we add a strong layer of tape.

Step 3: Making the Target.

Picture of Making the Target.

Now take the thermocol sheet and with the help ofpaint and bottle cap draw or paint 9 circles as shown in fig 1.

After that hang the thermocol sheet somewhere to shoot at it but don't hang it in a populated spot.

Step 4: How to Shoot

Picture of How to Shoot

first of all put your bullet inside the balloon and then strech the balloon aim snd shoot . as shown in the above pictures...


MsSweetSatisfaction (author)2014-09-27

Neat design, here's an instructable on how to use the editor in case you want to get rid of those extra steps:

Thanks for sharing!

no i should be the one to thank u

About This Instructable




Bio: Jack of all trades, master of none.
More by mchhabra1:HexBug BattleBotPaper SpringRam Ladoo
Add instructable to: