Introduction: Finger Snowboard

finished

Step 1: Materials

u need...
-1 sheet of paper
-liquid glue
-popsicle stick

-1 teck deck with wheels
-1 without wheels

Step 2:

take a peice of paper

Step 3:

add glue to half of paper (spread with popsicle stick)

Step 4:

fold in half

Step 5:

repeat to more times you should have a paper roughly 10 1/2x7 cm.

Step 6:

smoosh paper between teck decks.

Step 7:

clamp (48 hours)

Step 8:

trace board

Step 9:

when dry cut out

Step 10:

laminate it(waterproof) or cover in scotch tape

Step 11: Boots

if you want you can attach your own boots i used the hard paper left over(the board trimmings)









please comment

Comments

author
diy+man101 made it!(author)2009-12-14

                                    .-" " " "-.
                                  /              \
                                /_           _  \
                               / /  \         /  \  \ 
                              l  \_ \      /  _/  l
                               \         ll         /
                                 \                /
                                   \    __    /
                                    ' . __  . '
                                       l      l
                                       l      l
                                 
                                     

About This Instructable

2,012views

1favorite

License:

Bio: im stupid
More by diy man101:how to braidfinger snowboard
Add instructable to: