Introduction: Handy Nails/screws/nuts

Picture of Handy Nails/screws/nuts

this will help you have your nails/screws/nuts handy everywhere!

no more climbing up&down; the ladder to get another screw/nail/nuts!

Step 1: Get All the Materials Needed!

Picture of Get All the Materials Needed!

you don't need much for this project

-a small bottle (i used a middle-sized one)
-some foam (optional,its for more confortability)
-a magnet (preferably a powerfull one)
-forget the rubber bands,get some velcro,it's better
-glue stick

Step 2: Get All the Tools Needed

Picture of Get All the Tools Needed

once again,you don't need a lot of tools for this product

all you need is:
-an xacto knife (or scissors)
-and a hot glue gun

Step 3: Ok So Begin

Picture of Ok So Begin

ok so the first step is to remove the paper thing and cut the middle part which is soft to touch

Step 4: Cut,cut,cut...

Picture of Cut,cut,cut...

now cut the part where the paper was glued on...

Step 5: Cut,cut...

Picture of Cut,cut...

now cut what you have left in half...

Step 6: The Magnet

Picture of The Magnet

now hot glue the magnet to one of the 2 parts you got from step 5,IN THE MIDDLE

Step 7: The Other Half

Picture of The Other Half

now on the other half,cut a hole the size of the magnet,IN THE MIDDLE

Step 8: The Other Half,part 2

Picture of The Other Half,part 2

now hot glue it on the same level as the magnet

Step 9: The Feam (optional)

Picture of The Feam (optional)

now hot glue the foam on the side that touches the wrist so you can be more confortable

Step 10: The -->ADJUSTABLE<-- Strap

Picture of The  --&gt;ADJUSTABLE&lt;-- Strap

hot glue the velcro on one side and the strap with the other part of the velcro on the other side

Step 11: Yay!

Picture of Yay!

well,you're pretty much done!

do you have any comments,questions,imporoovements?

post them here!

remember to rate my instructable.please?

BTW,mine can hold up to 60 screws


bricabracwizard (author)2012-10-01

Great idea! You could use this for tools too. I've given you a 5!

ChrysN (author)2009-07-21

This looks interesting, do you have a picture of it in action?

coolrobot (author)ChrysN2009-07-21

thanks i will try to post a vid of it in action,if i can't do it i'll just put a picture of it

ChrysN (author)coolrobot2009-07-22

Wow, that holds a lot of screws, I can see how handy it would be. Great picture.

coolrobot (author)ChrysN2009-07-22

thanks,i would apreciated if you rate it =D

AndyGadget (author)2009-07-21

Handy idea. I've been known to go up a ladder with a half-dozen nails or screws between my lips. Not always successful as sometimes the 'gag' reflex kicks in after a bit.

About This Instructable




More by coolrobot:how to make a simple LED testerhandy nails/screws/nutshow to make a homemade ON/OFF switch
Add instructable to: