Instructables
Picture of how to make a leg for a sofa chair
two pieces of 3/4 ply one piece of 1/2 ply same color of sofa leg your going to duplicate
measuring tape, glue, a pencil and clamps, table saw, miter saw, belt sander.
 
Remove these adsRemove these ads by Signing Up

Step 1: Making your lines

Picture of making your lines
first you will need to measure existing legs width, and then transfer measurement onto 3/4 ply but add a quarter on in inch more. Now do the same on the 1/2 inch ply

Step 2: Ripe ply

Picture of ripe ply
Now with a table saw rip ply-woods  to desired width

Step 3: Cutting with the miter saw

Picture of cutting with the miter saw
Now measure legs length and transfer length to the pieces of plywood you ripped but give yourself a quarter of an inch more to measurement. then cut them

Step 4: Trace to ply

Picture of trace to ply
now you trace leg onto all pieces of ply

Step 5: Sand to disired size

Picture of sand to disired size
Now with a belt sander and grinding disc sand all pieces of ply to desired size 

Step 6: Trace and cut

Picture of trace and cut
Now you lay your cut pieces of ply and you trace the out line of how they meet. then you cut them on miter saw then line up again until you have a rough cut out of your leg

Step 7: Rough outlook on leg

Picture of rough outlook on leg
this is what it should look like before you glue

Step 8: Apply wood glue

Picture of Apply wood glue
Now you apply wood glue to all pieces 

Step 9: Clamping it

Picture of Clamping it
Now you clamp it tight from all angles

Step 10: Routing the edges

Picture of routing the edges
Now you will need to route all edges to a 1/8 inch round

Step 11: Finished leg

Picture of Finished leg
Now your all complete. You will need to find correct threaded bolt rode drill and glue new rode in. 
useraaaaa2 years ago
i didnt get it..
get 4x4
cut prism with band saw..
This is allot less likely to split than a solid piece of wood.
Very nice! It looks great.