Instructables
Picture of how to make a longbow string
you will need
drill
clamp
a sharp tool
string to start off u need 2inchs longer in string then your bow
 
Remove these adsRemove these ads by Signing Up

Step 1: Cutting the string

Picture of cutting the string
cut the string 2inches longer then your bow like i did.

Step 2: Tieijng the string

Picture of tieijng the string
tie the string in to a knot to hold it tight

Step 3: Puting in vice

Picture of puting in vice
now put the knot u just tied in to the vice tight

Step 4: Puting in the drill

Picture of puting in the drill
put the end of other side of the string in to the drill and tighten then spin the drill to twist in this form.

Step 5: String

Picture of string
now your string should me tight like this but not to tight or it will curl up when you take it out of the vice.

Step 6: Tie the knot

Picture of tie the knot
take it out of vice and drill and tie the side in the drill like you did the one in the vice

Step 7: Tie the loop

Picture of tie the loop
now tie in to a loop that will fit your bow snugly but not tight

Step 8: You are done

now you are done if this does break just add 1 more strand and it will hold up to 1-60 draw lbs