loading

How to make a multmeter test probe from a pen and a rivet

Picture of how to make a multmeter test probe from a pen and a rivet
Fotos-0018.jpg
when I was cleaning my workshop I found my multmeter, but it was missing a test probe, so I decided to build my own.
 
Remove these adsRemove these ads by Signing Up

Step 1: Materials and tools.

Picture of materials and tools.
all you need is an old pen (the best is one like mine), a rivet with sharpen point and electrical tape.
the tools are only hot glue gun and a plier.

Step 2: Preparing the rivet and the pen

Picture of preparing the rivet and the pen
Fotos-0008.jpg
Fotos-0009.jpg
Fotos-0010.jpg
Fotos-0011.jpg
first, disassemble the pen and the rivet.
to disassemble the rivet,secure the outide part using the plier and kick it into someting

Step 3: Assembling the test probe

Picture of assembling the test probe
Fotos-0014.jpg
Fotos-0015.jpg
Fotos-0016.jpg
Fotos-0017.jpg
Fotos-0018.jpg
first, tie the multmeter's wire in the inside part of the rivet, after insert the rivet and the wire in the pen until reach the desired lenght and glue it, after wrap all in electrical tape. once you've done advance to step 4

Step 4: You're done

Picture of you're done
congratulations, you just made your multmeter test probe.
pen-0.00€
rivet-0.00€
electrical tape-0.00€
total-0.00€