Step 1: Equipment and materials
-paper clip(forgot in image
- hack saw or scissors
- Bic pen
- Sand paper
Step 2: Step 1
1. Remove the yellow tip from the blue connector thing.(the yellow tip is connected to the Ink tube.)
2. Remove the blue connector
3. Remove end cap( i used a screwed driver)
Step 3: Step 2
2. sand and file the surfaces that has been cut
3. Cut the bottom part of the blue connector just below the bic logo. Afterwards file and sand it. You will only need the part without the bic logo.
4. hot glue the blue connector bit that can fit inside the pen tube.( push it in so the whole thing is inside the tube. just at one end. The picture next will display what i mean.)
Step 4: Step 3
2. Start sinking the knife into the pen tube and sliding it forwards to create a long slot.
3. start carving the edges and filing it so it becomes wider. 3 mm wide and length varies on how many springs the pen gun contains.
4. sand edges so it is smooth and remove unneccessary pieces of plastic hanging on the edges.