Step 3: Drilling

Drill holes according to the diagram and place 2 dowels into the holes. The holes can't be deeper than 1/2 an inch or they will go in too far. Don't forget to glue.
<p>cool me and my friends setup a club for ruber band guns and iv built a sniper and a min gun </p>

About This Instructable


5 favorites


Bio: I have been building since I was 4 and growing plants since I was 5.
More by project_builder: Emergency USB Charger How to make the worlds easiest power supply Introduction to the Hobby of Electronics
Add instructable to: