Introduction: How to Make a Somewhat Solid Lightsaber Blade

Picture of How to Make a Somewhat Solid Lightsaber Blade

Hello this instructable will teach you how make a somewhat solid lightsaber blade.

Step 1: Gathering Materials

1.a toy lightsaber (Which you don't want that dumb collapsable blade on any more)
2. two monster bubble rod sword things (they are at wal-mart for 2 dollors each)
3. a roll of clear packing tape
4. screws (To hold the whole blade on.)

Step 2: Pull Off the Old Blade

Picture of Pull Off the Old Blade

Pull or take off the old blade,  WITHOUT destroying the handle ad get ready
 for the next step.

Step 3: Preparing the Blade

Picture of Preparing the Blade

cut off that srcew threaded plastic part and the top
 on one of the rods so you ony have a clear tube

Step 4: Put the First Tube Into the Handle

Picture of Put the First Tube Into the Handle

wrap one of the tube ends in tape and insert tube into the handle. if it looks like the picture you are doing good( it will take trial and error to get the tape amount right)

Step 5: Preparing the Second Tube

Picture of Preparing the Second Tube

the second tube wrap tape around the screw thread until  it fits snugly . when the tubes are  together
wrap clear tape around the seams and join them together

Step 6: Congratulations You Are Done

Picture of Congratulations You Are Done

but if your going to fight with it screws should  go into the base and enjoy


snake95 (author)2015-03-22

I made one like this a wile ago go check it out :)

mikethemaster123 (author)2010-10-27

how much did tht lightsaber cost

cah el (author)mikethemaster1232010-11-23

i got the the main lightsaber at a garage sale for two dollars

About This Instructable




More by cah el:How to make a metal grappling hook without weldinghow to make a bladder system for a water gunhow to make a power rangers like gun sword
Add instructable to: