iCylinder

Step 5 Setup power cable

In this step you will learn how to make the power cable. Take the power transformer that works with your amplifier and separate the two wires in three places, and tape the ends of area that is seperated so the whole thing doesn't split apart. Strip the two wires by pinching the ends of what is to be stripped off with the wire strippers, and use the pen knife to cut horizontally between the two pinched areas to get off the insulation without cutting the wire(that was hard to explain but i did as best as i could). This should look like the first picture. You need to have three sets of these strippings. Solder bits of electrical wire about 3 inches long to each wire on the three sets of strippings and cover the uninsulated wire with electrical tape to prevent short-circuit. The final power cable should look like the second picture.