Print PDF
Favorite
Email
Step 3Take the Second Binder Clip and Piggy Back it onto the First Stand
The result of Step 2 is Version 1.0 of the binder Stand as seen in Cult of Mac. I wanted to be able to have my iPhone in the stand vertically also but a single binder clip didnt provide enough support to hold up the iPhone vertically. So Binder Clip Stand 2.0 was born.
This is a bit tricky to explain but check out the picture for more information. The second clip should grab on the first clip and will end up being parallel to the desk. Setup the first one as if you have an iPhone on it and the from the back squeeze the second binder clip so it is wider than the first and go straight into the first until the front edge of the top of the clip is pushing the vertical iPhone support up a bit.
You now have a double sized base and it will support your phone standing vertically.
This is a bit tricky to explain but check out the picture for more information. The second clip should grab on the first clip and will end up being parallel to the desk. Setup the first one as if you have an iPhone on it and the from the back squeeze the second binder clip so it is wider than the first and go straight into the first until the front edge of the top of the clip is pushing the vertical iPhone support up a bit.
You now have a double sized base and it will support your phone standing vertically.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
