loading

This is an intermediate level k'nex car. It is 6 wheel drive and goes faster than usual because of the gears.

Step 1: These Are the Peices You Need

YOU NEED

Rods:

5 long grey

48 short green

15 short white

TOATAL: 68

CONECTORS:

4 WHITE

10 YELLOW

4 PURPLE

4 red

2 light grey

2 green

8 orange

22 dark grey

16 dark brown

TOATAL 76

OTHER:

4 red medium gears

6 dark blue small gears

6 medium wheels

1 two speed motor

TOATAL 17

Step 2: Make Two of These

Step 3: Put the Motor Inbitween the Two and Put the White Rod on the Back

Step 4: Make Eight of These and Put Them to the Side

Step 5: Push the First Two Long Rods Through the Front Two Holes

Step 6: Get the Eight Things and Line the Up on Thier Side and Put Them in the Gap So You Can Push the Last Three Long Rods In

Step 7: Push the Four Gears on to the Long Rods

Step 8: Add the Small Gears Onto the Gaps

Step 9: Add the The Light Brown Clips on But Put One on the Red Gears and Two on the Blue Gears

Step 10: Push the Wheels on Leaving One Rod Inbitween. Make Sure the Points on the Brown Clip Goes in the Little Hole

Step 11: Finaly, Add the Dark Grey Clips on Next to the Wheels and Your Done!

<p>Looks good!</p>
<p>Sweet.</p>
<p>Great looking car. Thanks for sharing it!</p>

About This Instructable

247views

3favorites

License:

More by Rudy3983:How to make a k'nex piston k'nex 6 wheel drive car 
Add instructable to: