Introduction: Knex Bullpup Rifle T.A.R 21
here is my first bulpup rifle
it is a T.A.R 21 bullprup rifle (that meens that the mag is behind the handle)
i used the dunkis trigger system (slimd it)
i also used a nice cooking system you can easely put it in it don't fall out of the gun and you can easely put it out
i think it's never been used by anybody
i also used a very well rail system i think SK disigned it and i little modded it
some pros and cons
pros:
nice sliding trigger (dunkis)
nice rail system
comfy handle
comfy front grip
nice sight
new cooking mechanism
shoots white rods
con's:
the ram is a brown/ red rod
i only get around 30 feet
thanks by PiTBuLL892
PIECE LIST
connectors
dark grey:28
light grey:3
orange:61
red:50
green:36
yellow:117
white:34
3D connectors
blue:8
rods
green:272
white:84
blue:27
yellow:7
miscellanious
blue spacer:2
grey spacer:4
tan clip:6
male ball joint:1
y clip:12
broken parts
see step 3, pic 4
Step 1: Simple Step
please do not say that you can't follow this
make to of those
Step 2: The Handle
follow the pics this can be hard to follow
the next step it's harder to follow to be prepared
i hope it clear enough
Step 3: The Barrel + Trigger Mech
i think this is the hardest step
trigger mech slimd it from the dunkis bullpup rifle
Step 4: The Stock
makin the stck
note the ram use a tan red rod
not a red rod
Step 5: Mag, Sight and Grip
easy
note there is tape on the green rods
Step 6: Add the Last Plate
this is the same plate that you made in step 1
Step 7: Rubberbands
add rubberbands
and your done please rate and comment
don't forgot the sub
thanks for rating