Knex Knife and Holder

1,838

5

18

Published

Introduction: Knex Knife and Holder

About: nothing special just ╔═╦╗╔╦╗╔═╦═╦╦╦╦╗╔═╗ ║╚╣║║║╚╣╚╣╔╣╔╣║╚╣═╣ ╠╗║╚╝║║╠╗║╚╣║║║║║═╣ ╚═╩══╩═╩═╩═╩╝╚╩═╩═╝

 my knex knife

Step 1: The Knife

 1:make
2:make
3:attach
4/5:attach white rod

Step 2: The Holder

 1:build
2:make
3:attach
4:attach
5/6:put some tape on
6:make
7:attach

Share

    Recommendations

    • Spotless Contest

      Spotless Contest
    • Slow Cooker Challenge

      Slow Cooker Challenge
    • Make it Move Contest

      Make it Move Contest
    user

    We have a be nice policy.
    Please be positive and constructive.

    Tips

    Questions

    18 Comments

    Holder should be longer and I think there should be a clip so you can actually wear it instead of having t hold it.

    holder should be longer, slit you own leg open.

    2 replies

    Good, but you need to make the holder a little bit longer so that the sharp end doesn't stick out. 3.5.

     Im dutch too but speak english here pls

    waarom?
    ik ken hem dus waarom zou ik dan niet nederlands gaan praten?

     Its not very polite against others

    is dat zo belangrijk? alleen maar een kort zinnetje van; 'goed idee' ?
    bij mijn eigen instructable praat ik egt wel engels hoor

     Ok ,i can live with that

    Eigenlijk boeit het niet zo...   ; )

    nope,
    heb je mijne al is gemaakt?
    m93 raffica

     Nee, maar heb hem wel *4.5 gerate. Het is een "gewoon" pistool. Maar ik vind die stock wel iets hebben.

    No, but I rated is *4.5. Its just a normall pistol. But is like the stock.

    Idea? Have you not seen TAK?

    Yes i commeted on it

    not bad!

    yeah this would be awsome if the blade was in mettalics