Print PDF
Favorite
Email
Step 6Assembly
LAYER 1 start by arranging all of the pieces, then take M and two of the bolts and insert them head side down in the wood and cap it with piece D then use the small countersunk screws to seal the bolts in. the large holes in the side of the wood is for a screw driver to turn the bolts. as seen on image 1-7
LAYER 2 add the two tubes on top of the threaded bolts then instal piece L and peace N then place both of piece R the washers on the opposite side of the the screw driver as seen on images 8-11
LAYER 3 place 3 of piece K and the scissors piece P on opposites sides as seen on image 12-15
LAYER 4 add one peace K and peace I the ruler on opposite sides then cap it with peace C as seen in images 16-20
LAYER 5 add two peaces of peace L then place peace E and peace U on either side as seen in images 21-23
LAYERS 6 and 7 are much the same add four peaces of K to one side and peace B and J as see in image 24-31
LAYER 8 if you using a 3/16 knife peace A then add peace L twice then peace G, if your using a 1/8 blade then remove peace A, ether way place peace F to the opposite side of the knife.
LAYER 9 place peace H on peace O then screw it down after placing the nuts in the square holes, then take the three 3/4 threaded rods and file a slot in the top of the rod so that you can use a flat head screwdriver to turn it, next use an all to line up all the holes then screw down the threaded rods in the holes. finish this by capping it with the peace H and O combination and screwing it in and your done.
LAYER 2 add the two tubes on top of the threaded bolts then instal piece L and peace N then place both of piece R the washers on the opposite side of the the screw driver as seen on images 8-11
LAYER 3 place 3 of piece K and the scissors piece P on opposites sides as seen on image 12-15
LAYER 4 add one peace K and peace I the ruler on opposite sides then cap it with peace C as seen in images 16-20
LAYER 5 add two peaces of peace L then place peace E and peace U on either side as seen in images 21-23
LAYERS 6 and 7 are much the same add four peaces of K to one side and peace B and J as see in image 24-31
LAYER 8 if you using a 3/16 knife peace A then add peace L twice then peace G, if your using a 1/8 blade then remove peace A, ether way place peace F to the opposite side of the knife.
LAYER 9 place peace H on peace O then screw it down after placing the nuts in the square holes, then take the three 3/4 threaded rods and file a slot in the top of the rod so that you can use a flat head screwdriver to turn it, next use an all to line up all the holes then screw down the threaded rods in the holes. finish this by capping it with the peace H and O combination and screwing it in and your done.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
