Step 1: The design
I found this download, that is the design layout. I first made the eye covers out of plexy glass by cutting them into squares then sanding the edges.
Step 2: Side cylinders
I used 3" pvc for thesejust cut the m to the size desired. for the middle I used a 2" pvc end cap and just drilled holes in it. then I made a plexy circle the size of the 3" pvc and drilled holes in them. on the other side of the cylinder another circle piece of plexy just with a large hole so the 1 1/2" pvc will fit and slide in then I just glued every thing together to make 1 piece.
Step 3: Put it together
in order for the cylinders to fit on the middle piece you need to grind/ cut off some pieces (see picture. after you do that take out you hot glue gun and glue the 2 side piece to the middle piece
Step 4: Glue, glue, and more glue
for the face part I used an old plastic ball the kind you would find at wallmart in the tall racks in the toy section. then just cut to the design on the download. then I gleu the mouth hole to the middle piece of the pvc build.
Step 5: Finishing up
I used large red rubber bands to hold the mask on my face. here is My end results. I will remake the face part and I will update!! now go join the umbrella corporation!!!