Making of Table Top Water Fountain

making of table top water fountain is not an easy job but u can get an idea of making it by following my steps.
you need:
1) m seal
2) 12v motor (used in tape recorders)
3) plastic round cap
4) plastic wheel (to fix in the fan)

well here m seal is a wax based gum u can mold the gum as u like. i masked a fan u can see in the pitcher below it is used in the pump
http://youtu.be/F5xPI9pDNvo

Step 1:

12 volt adopter is used for safety purpose

Step 2:

<iframe width="560" height="315" src="http://www.youtube.com/embed/F5xPI9pDNvo" frameborder="0" allowfullscreen></iframe>

Step 3: