Is it possible to take out the ring in the middle, without bending both side of the wire? Yes! I'll show you how to make it and do the trick.
Step 1: Measure the Wire
You need to find wire, any kinds of wires easy to bends with the cutter plier.
You will need ( 2 = 25cm ) and ( 2 = 3cm)
Step 2: Bends the Wire
2=25cm bend as shown picture below and 2=3cm make it into circule and solder it.
Step 3: Bend
2= 25cm bend it as shown below picture and put the 2=3cm into each opposite side and solder it.
Step 4: Trick
after the soldering find a ring and place the ring in the middle and pull eas opposite side and the ring will stay in the middle between the two circule, watch my video for more understanding how the trick work.