Print PDF
Favorite
Email
Step 4Ataching the ignitor
-Two extra wires should be atached to the metal part and existing wire on the ignitor.
-Then the exposed ends of the wire should be wrapped around the metal part of the thumbtack.
-Then the thumbtacks should be pushed in at a 90 degreese apart from each other one inch from the cap (refer to second picture).
-It can be shot like this or you can see further instructions on how to make it all into one handheld package.
-Then the exposed ends of the wire should be wrapped around the metal part of the thumbtack.
-Then the thumbtacks should be pushed in at a 90 degreese apart from each other one inch from the cap (refer to second picture).
-It can be shot like this or you can see further instructions on how to make it all into one handheld package.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
