Print PDF
Favorite
Email
Step 3Restrictions!
unfortunately every Nerf gun has restrictions, however, you can take them off, by following this step
First. open up the chamber that holds the Nerf darts, and carefully pry it open with a screw driver and watch all the little wimpy springs and forks fall out, once they are all gone just put the end back on the chamber.
First. open up the chamber that holds the Nerf darts, and carefully pry it open with a screw driver and watch all the little wimpy springs and forks fall out, once they are all gone just put the end back on the chamber.
| « Previous Step | Download PDFView All Steps | Next Step » |
12
comments
|
Add Comment
|
4
May 3, 2011. 2:19 AM
HighWing
says:
HighWing
says:
In my experiences, removing those actually reduces the range a dart will fly! I am fairly certain those are actually put in to prevent large air blasts during a dry fire. The only thing that will actually increase the range of the dart is replacing the air compressor spring.
Reply
8
Jul 9, 2011. 1:00 AMsithlil
says:
very, very wrong
Reply
6
May 30, 2011. 7:50 PMinergy
says:
Wrong.
Reply
Apr 8, 2010. 5:04 PMcmccarty0724
says:
im having a hell of a time getting the nub off too.. pushing isnt helping, tried for half an hour... any other suggestions?
Reply
5
Apr 1, 2011. 4:37 AMTHECHINABOY
says:
me to but i dont see any silver peg on the back. could you add a pic?
Reply
11
Apr 8, 2010. 6:40 PMknuckel (author)
says:
also, it has been a while since i have done this, but look for a silver peg sticking out of the back and press on it realy hard and twist and it should come right off
Reply
11
Apr 8, 2010. 6:38 PMknuckel (author)
says:
trust me try relay hard, it is tough, make sure u have all of the skews un done, if necessary you may need to resort to pliers of a large size
Reply
3
Feb 2, 2011. 7:09 PMFurloy
says:
you need 2 cut the long things off and sand it down
Reply
11
Feb 4, 2011. 9:40 AMknuckel (author)
says:
i will try that next time i update this
Reply
6
Jun 24, 2010. 4:25 PMCaseBoy
says:
CaseBoy
says:
this link help me a lot... http://www.youtube.com/watch?v=egin2_oTs0w
Reply
May 12, 2010. 12:40 AMGreatClownKing
says:
I found if you take a pair of decent sized wire cutters and slide them under the front grey piece on the orange end of the barrel and squeeze it comes right apart no problem
Reply
11
May 15, 2010. 9:56 AMknuckel (author)
says:
exactly
Reply
1
Jan 20, 2010. 5:43 AMdany man148
says:
hi i am haveing problems with this step see i got the drum out but i cant seem to get the back off help!!!!1
Reply
1
Jan 20, 2010. 5:44 AMdany man148
says:
i even got the screws out...
Reply
11
Apr 5, 2010. 7:05 PMknuckel (author)
says:
just push it on realy hard and thyer is a silver thing in the coupel on the barrel
Reply
11
Jan 20, 2010. 4:17 PMknuckel (author)
says:
just push it on realy hard and thayer is a silver thing in the coupel on the barrel
Reply
 |
Add Comment
|
