Instructables
loading
loading
Picture of paper airplane tips
not good at making paper airplanes? then this is the instructable for you!
 
Remove these adsRemove these ads by Signing Up

Step 1: Air flow

Picture of air flow
dcp_5428.jpg
my finger is pointing the direction the air will flow with stabilizers and without stabilizers.

Step 2: Basic plane

Picture of basic plane
dcp_5430.jpg
dcp_5431.jpg
dcp_5432.jpg
to build the most basic plane you need to:

fold the paper's corners down to the midle,
then fold the corners in again,
now fold in half,
fold down wings,
and put on stableizers if needed!

Step 3: Flaps

Picture of flaps
you may want to put flaps on the plane if you want to steer it,just cut inch to a 1/2 inch flaps on the back.

(remember,flap up,that wing goes up,flap down,that wing goes down,example,both flaps up,the plane goes up)

Step 4: Blunt-nosed plane

to make the blunt-nosed plane you need to:

fold in half and unfold,
fold corner over a little off-center,
and do that to the other side,
fold nose up,
fold in half,
fold down wings,
and fold stableizers.
(this plane NEEDS stableizers)

Step 5: Trick plane

this is a more complicated plane that has a tail fin on the back and is totally customisable!
to make it you need to:
make a square by folding diagnaly and cutting off extra paper on the bottom,
then fold in half,(after you unfold it!)
fold down front corners,
fold down wings,
cut the tail fin by cutting up to the top of the wings,
fold the tail fin out.