Introduction: Powerful Blow Gun

Picture of Powerful Blow Gun

Powerful blow gun that shoots darts into trees.
WARNING IF SHOOT AT ANYTHING THAT CAN BREATHE CAN CAUSE SERIOUS INJURY! I AM NOT RESPONSIBLE FOR ANY ACTIONS INVOLVING THIS GUN!

Step 1: Materials

Picture of Materials

you need:
tape
hot glue
nails
2ft of half inch pvc pipe
magazine sheet
scissors

Step 2: Cut the Page

Picture of Cut the Page

Cut the page in half then into thirds.

Step 3: Tape

Picture of Tape

Grab one of the pieces u cut and three pieces of tape.

Step 4: Roll the Paper

Picture of Roll the Paper

Roll the paper so it is a tight cone.

Step 5: Add Tape

Picture of Add Tape

Add two pieces of tape so the cone keeps it's shape.

Step 6: Add the Nail

Picture of Add the Nail

Push the nail through the back so it sticks out the front.

Step 7: Cut It

Picture of Cut It

Slide the dart into your pvc so it has a tight seal, then cut it.

Step 8: Hot Glue

Picture of Hot Glue

Fill the dart with hot glue. Make sure there are no air bubbles. Then let it dry.

Step 9: Fire

Picture of Fire

Put the dart on the side where u will blow. Then blow!

Comments

Wow, how far can you shoot the dart?

my friend made an air gun that shoots theses like two inches into treees

About This Instructable

1,888views

8favorites

License:

Add instructable to: