Introduction: Psp Chargeing Pill Bottle

this bottle has small easy to build circuit to power a PSP in need of a charge
((((((((not responsible for damage electronics)))))))

THINK YOU https://www.instructables.com/member/Jacob+S./ FOR THE IDEA BUT I TICKED IT A LITTLE BIT
HERE IS A PDF OF THE DIAGRAM I MADE BETTER TO READ THEN IN STEP4 AND 11

Step 1: Get Your Parts to Getter

i got all of these parts at radio shack but the pill bottle my old meds from when i got sick but that another story

CIRCUIT

switch http://www.radioshack.com/product/index.jsp?productId=2062503
1/8 mono jack www.radioshack.com/product/index.jsp
5volt regulator http://www.radioshack.com/product/index.jsp?productId=2062599
9 volt clip [http://www.radioshack.com/product/index.jsp?productId=2062218

PLUG

dc plug for psp http://www.radioshack.com/product/index.jsp?productId=2102598
(make shure it fits your psp )
1/8 mono plug http://www.radioshack.com/product/index.jsp?productId=2062452
(IT HAS TO BE MONO OR YOU WILL SHORT)

Step 2: Get Your Tools

multimeter http://www.radioshack.com/product/index.jsp?productId=2103174
wire
cutting tools
solder
iron(mine is butane)http://www.radioshack.com/product/index.jsp?productId=2062753
9 volt battery
helping hands
shrink wrap

Step 3:

now lets build

Step 4: Wire Diagram

fallow back to this if needed it will help the pdf is a true diagram i made

Step 5: STEP ONE

WIRE CLIP TO THE SWITCH

Step 6: STEP TWO

WIRE SWITCH TO 5 VOLT REGULATOR PIN INPUT

Step 7: STEP THREE

WIRE OUTPUT TO POSITIVE PIN

Step 8: STEP FORE

WIRE NEGATIVE CLIP -------------------------\
WIRE GROUND PIN ON REGULATOR ----->-------- TOGETHER AND SHRINK WRAP
WIRE NEGATIVE PIN ON JACK---------------/

Step 9: Test to See If It Works

put the plug in the jack and the battery in the clip and check the volts with the multimeter red probe to pos. and black to neg. like in the drawing the meter should say around 5 or less volts

Step 10: Put It Together

I PLUG IN A FRESH 9VOLT BATTERY OOPS TOO SOON
1- I DRILLED THE HOLES FOR THE JACK AND SWITCH
2 - THEN PLUG THE BATTERY IN
3 - AND MAKE THE PLUG NEXT STEP

Step 11: Make the Plug and Done

make the plug part see drawing
((((((((not responsible for damage electronics)))))))
THINKS AND HAPPY MAKING

Comments

author
subnet12 (author)2010-02-25

oh sh** tha so kool

author
Chromatica (author)2010-01-16

BLURRY
BY THE WAY CAPS LOCK IS ON!!!!

About This Instructable

6,610views

7favorites

License:

More by lonemeno:remote start system for car truck and suvseat belt beltcar radio played in doors with out battery
Add instructable to: